Engine Driven Welder
| Powered by phpBay Pro |
Go-kart/ Dune buggy blueprints or plans?
Go-Kart/ Dune buggy plans or blueprints?
I want to build a two person go-kart with a 250 cc to a 600cc. Looking to get one to do some off roading not much but also work around the yard and land i have like pulling out dead tree branches and things, maybe to drive to and from my hunting standing and or without a deer in tow. Anyone know of any plans i am a welder and know my way around an engine but building a chassis is not in the knowledge yet.
Also i would like to have a short wheel base and a width of about 4 ft if not less...
Pulling trees and such you may want to consider a 1600 ish volks motor.
or using a FWD Mid engine design.
But the thing about buggies/sand rails is that in almost all cases you can save a lot of cash finding a complete one then building one from the ground up(works for many vehicle builds).
But then you loose out on saying you built it.
Now you can buy a complete frame(or copy one) then throw something like a manual rack/pinion steering setup with a basic sway coil over design. And most of these can be found by a (google) buggy/sand rail or race car search.
The designs will change but find what works and copy it.
For a off road buggy. You may want to start with a sand rail frame and fab in motor mounts for a FWD engine in the passenger side. No t case needed. The limited slip will give you a little play but for the most part you will have a very light weight 4wd buggy that can pull your stuff around without spinning the wheels all over the place.
Whoops missed the two person thing well it can still be done you just have to position the motor behind the passenger with the drive shafts between you both(covered of course).
Goodluck
| Powered by phpBay Pro |
Tags: engine driven welders, engine driven welders for sale, lincoln engine driven welders, used engine driven welders, used engine driven welders for sale
Leave a Comment
You must be logged in to post a comment.